KING Jack OA8300 Manual

Also see for OA8300: Manual

KING Jack OA8300 Manual Manual pdf 2 page image

Page 2POLE MUST BE STATIONARY:NOT ON A VEHICLE.This is a directional antennaand should be rotated on themaximum signal reception.Option 1: BAT WING STYLE REPLACEMENT2. Attach the RV antenna bracket to the KING Jack antenna with the 4 supplied screws.clips (use new supplied retaining clips if necessary). You must mount antenna in relation to poles as shown below.4. Fill end of existing coax cable with supplied dielectric grease and screw to antenna (DO NOT OVERTIGHTEN).Note: If existing coax connector is corroded or damaged, replace with supplied new connector.Option 2: POLE MOUNT BRACKETsame screws and washers.3. Place the clamp around an appropriate pole and tighten wing nuts.4. Fill end of coax cable (sold separately) with supplied dielectric grease and screw to antenna (DO NOT OVERTIGHTEN).connector. Route coax cable and make appropriate connections.IMPORTANT! Make sure tomount head in relation to poleheights as shown.This will allow poles to fullyretract to stowed position.

/ 4

Related manuals for KING Jack OA8300