Menu
Halley BCG1E34F Owner's Manual
                | |
GB-11GBADJUSTING THROTTLE CABLE• The normal play is 1 or 2 mm when measured at thecarburetor side end. Readjust with the cable adjusteras required.(1)(1) Cable adjusterADJUSTING IDLING SPEED(1) Idle adjusting screw1. When the engine tends to stop frequently at idlingmode, turn the adjusting screw clockwise.2. When the cutting head keeps rotating after releasingthe trigger, turn the adjusting screw counter-clockwise.NOTE• Warm up the engine before adjusting the idling speed.CUTTER APPLICATION CHART• Replace by a suitable recommended cutting attach-ment according to the object to be cut.• When replacing blade always be sure to use productswhich have been recommended by your dealer.WARNING• When sharpening, removing, or reattaching the blade,be sure to wear thick, sturdy gloves and use onlyproper tools and equipment to prevent injury.8. Operation.04 in(1)METAL BLADE USAGE1. Check the nut to fasten the blade and be sure the nuthas no fault, and no abrasion.2. Be sure that the blade and the holder have been fas-tened according to instruction and the blade turnssmoothly without abnormal noise.WARNING• The rotating parts fastened incorrectly maycause serious accident to the operator.• Make sure that the blade is not bent,warped, cracked, broken or damaged.• If you find any error to the blade, discard itand change new one which is recommendedby your dealer.• By using the shoulder strap, hang the unit on yourright side. Adjust the strap length so that the cuttinghead may become parallel to the ground.WARNING• Make sure to use shoulder strap and debrisguard. If not, it is vary dangerous when youslip or lose your balance.T3189-15102(1-2 mm) |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved