EN Installation3. Space requirementsRequired space to open the door (Fig. 3):Widthin mm Depthin mm Distance to wallin mmW1 W2 D1 D2 D3 D4595 806 577 1174 1202 1004. Ventilation spaceFor safety and energy reasons, the required ventilationdistance of 10 cm in all directions must be observed(Fig. 4).WARNING!▶ Keep ventilation openings in the appliance or in the in-built structure clear of ob-struction. This refrigerating appliance is not intended to be used as a built-in appliance1. Unpacking▶ Take the appliance out of the packaging.▶ Remove all packaging materials including the foam base and all adhesive tape hold-ing the accessories.2. Environmental conditionsthe temperature inside the appliance and its energy consumption. Do not install the appli-ance near other heat-emitting appliances (ovens, refrigerators) without isolation.155. Aligning the appliancesurface.1. Tilt the appliance slightly backwards (Fig. 5).2. Set the adjustable front feet to the desired levelby turning them.3. The stability can be checked by alternatelybumping on the diagonals. The slight swayingshould be the same in both directions. Other-wise the frame can warp; possible leaking doorseals are the result. A low tendency to the rearfacilitates the closing of the door.1.2.3.534More than 10 cm from the topMore than10 cm fromthe leftMore than10 cm fromthe leftMorethan 10cmfrom the rear