2EnglishUnpacking Your Wine Cellar1. Remove all packaging material. This includes the foam base andall adhesive tape holding the wine cellar accessories inside andoutside.2. Inspect and remove any remains of packing, tape or printedmaterials before powering on the wine cellar.Leveling Your Wine Cellar• Your wine cellar has leveling f eet which are located in the frontand rear corners of your wine cellar. After properly placing yourwine cellar in its final position, you can level your wine cellar.• The leveling feet can be adjusted by turning them clockwise toraise your wine cellar or by turning them counterclockwise to loweryour wine cellar. The wine cellar door will close easier when theleveling feet are extended.Proper Air Circulation• To assure your wine cellar works at the maximum efficiency itwas designed for, you should install it in a location where there isproper air circulation, plumbing and electrical connections.• The following are recommended clearances around the winecellar:Sides .......................... 2" (50mm)Top............................. 2" (50mm)Back ........................... 2" (50mm)• Do not over fill your wine cellar for proper wine cooling.Note: If your wine cellar has been tilted for any reason, wait 24 hoursbefore plugging it in.Installing Your Wine Cellar