Haier LW-120 User Manual

Also see for LW-120: User manual User manual User manual

Language

English

Contents

English2

Français17

Español32

Haier LW-120 User Manual Manual pdf 7 page image

1. Remove all packaging material. This includes the foam base and alladhesive tape holding the freezer accessories inside and outside.2. Inspect and remove any remains of packing, tape or printed materialsbefore powering on the freezer.3. Select a suitable location for the freezer on a hard even surface awayfrom direct sunlight or heat source e.g. radiators, baseboard heaters,cooking appliances etc. Any floor unevenness should be corrected.4. Do not install your freezer in any location not properly insulated orheated e.g. garage etc. Your freezer was not designed to operate intemperature settings below 32˚ F (0˚C).5. Your freezer is designed for freestanding installation only. It should notbe recessed or built-in.6. Place the freezer on a floor strong enough to support it fully loaded.7. When moving the freezer, never tilt it more than a 45-degree angle.This could damage the compressor and the sealed system.8. In case you unplug your freezer or experience an electrical outage,allow 5 minutes before plugging it back in.Installing Your FreezerEnglish• Casters are to be installed on the 4 bottom corners. Slide caster in theprovided slot. Once the caster is in place, secure it with a providedscrew.Note: 1 Phillips Head screwdriver required.Installing CastersScrew6English

/ 48

Questions and answers

Heed help?

Ask question about this manual

Related manuals for Haier LW-120