Haier LET32T1000HF Instruction Manual

To switch between different input sources, use the 'Source' button on your remote control. This will allow you to cycle through the available input options such as HDMI, AV, and USB.

If your television does not turn on, first check that the power cord is securely connected to both the television and the power outlet. Ensure that the power outlet is functioning by testing it with another device. If the issue persists, try resetting the television by unplugging it from the power source for a few minutes and then plugging it back in.

To connect a DVD player to your Haier LET32T1000HF TV, you can use the SCART input or the HDMI input. Refer to the 'Connecting a DVD player to your TV' section on page 10 of the manual for detailed instructions.

If the product is making abnormal sounds, disconnect the power supply immediately and contact the authorised after-sales service for assistance.

No, to avoid fire hazards, do not use this product in direct sunlight or close to heat sources. Keep the product away from transformers or heat sources to avoid the risk of fire.

To clean the television, unplug it first and use a soft, dry cloth. Do not use any chemicals and ensure that no water drops get into the product.

To use your Haier LET32T1000HF TV as a monitor for your personal computer, follow these steps: 1. Turn off the power on your TV and PC. 2. Connect a D-type 15-pin VGA interface cable to the VGA video interface connector on the PC and the other end to the PC interface connector on the TV. 3. Tighten the screws on the VGA connectors and connect the audio cable to the audio input socket on the back of the TV. 4. Switch on the TV first, followed by the PC. 5. Press the button on the TV or TV remote control to set the video input mode to PC. 6. Adjust the resolution, refresh rate, brightness, and contrast on the menu until the picture is clear.

To adjust the sound settings, press the MENU button, select Sound, and then press OK to enter. You can adjust various sound settings such as Balance, Bass, Treble, and Sound mode to suit your personal preferences.

To switch the display and magnify the image, press the button that switches the display from the top half of the screen to the bottom half.

To exit the USB mode, press the EXIT button on the remote control. It is important not to remove the USB device from the TV until you have exited USB mode to avoid damaging the USB device.