Haier LEC24B3320 User Manual

Please refer to the Installation section on pages 6-9 of the manual for detailed instructions on how to install the Haier LEC24B3320.

For instructions on using the remote control, please refer to the Remote Control section on page 10 of the manual.

Refer servicing to qualified service personnel. Do not open the cabinet as high voltages are used in the operation of this television receiver.

Never stand on, lean on, or suddenly push the television or its stand. You should pay special attention to children. Do not place your television on an unstable cart, stand, shelf or table. Serious injury to an individual and/or damage to the television may result if it falls.

You can connect your PC to the Haier LEC24B3320 TV using the built-in VGA port. This allows for a true digital connection and a complete home theater experience.

To adjust the volume, press the 'VOL+' or 'VOL-' button on the remote control or the side panel. The 'VOL+' button will increase the volume, and the 'VOL-' button will decrease it.

To connect your computer to the Haier LEC24B3320 TV using a VGA cable, follow these steps: 1. Ensure both the TV and computer are powered off. 2. Connect a VGA cable from your computer to the TV. 3. Connect the power cord to the TV. 4. Turn on the TV and switch it to PC mode. 5. Turn on your PC.

The Haier LEC24B3320 TV supports an aerial connection with IEC (female) and an input impedance of 75 unbalanced.

The Haier LEC24B3320 offers the following resolution settings: 640x480, 800x600, 1024x768, 1280x1024, and 1366x768.

To change the resolution on the Haier LEC24B3320, you can select the desired resolution from the preset modes available. The manual does not specify the exact steps, but typically, you would navigate through the menu settings to select the desired resolution.