Haier LE50K6500U Instruction Manual

To connect your Haier LE50K6500U TV to the internet, navigate to the 'Network' settings in the 'Settings' menu. Follow the on-screen instructions to select your Wi-Fi network and enter the password.

If your Haier LE50K6500U TV is not displaying any picture, first ensure that all cables are securely connected. Check the power source and try turning the TV off and on again. If the issue persists, refer to the 'Trouble shooting' section in the manual for further guidance.

To avoid damaging the LCD screen, do not use any abrasive cleaners and avoid contact with objects that may scratch the screen. Additionally, do not put the TV set near sources of humidity to reduce the risk of electric shock and fire.

Refer servicing to qualified service personnel. Do not remove the cabinet back from your set as high voltages are used in the operation of this television receiver.

Do not expose the television receiver to rain or moisture. Additionally, do not drop or push objects into the television cabinet slots or openings, and never spill any kind of liquid on the television receiver.

To assemble the base stand, place the panel side of the TV on the platform and insert the two stands into the TV, ensuring the screw holes of the stands correspond to the right holes of the TV. Then, fix the screws on the bottom of the back cover, one for each side, to complete the assembly.

The Haier LE50K6500U television is compatible with wall mounting brackets that adhere to the VESA standard. The specific VESA pattern for the 50" model is 200mm x 200mm, and for the 65" model is 400mm x 200mm.

The Haier LE50K6500U television comes with four M6X12mm screws that are used to fix the TV onto a wall mounting bracket via the VESA standard holes on the back of the television.

If there is no signal for the current signal source, the unit will automatically set to the standby state 15 minutes later. If you are not using the main unit for a long time, unplug the AC power cord from the AC outlet.

To change the aspect ratio, press the ▼ or ▲ button to select Aspect Ratio, and then press the ◄ or ► button to choose your desired option (e.g., Auto, 16:9, 4:3, Zoom1, Zoom2).