Haier LE40D32810 User Manual

When replacing the batteries in your Haier LE40D32810 TV, make sure to use the same or equivalent type to avoid the danger of explosion. Additionally, do not expose the batteries to excessive heat, such as direct sunlight or fire.

If the TV starts to overheat, unplug it immediately. Ensure that no vents or openings are blocked, as inadequate ventilation can cause overheating. Also, avoid placing the TV in confined spaces or in a box while using it.

If you notice smoke or a bad odor coming from the TV, unplug it immediately. This could indicate a malfunction, and it's important to address it promptly to prevent further damage or safety issues.

If the power cord or plug is damaged, you should refer all servicing to qualified service personnel. Do not attempt to repair it yourself.

When moving your TV from an area of low temperature to an area of high temperature, condensation may form in the housing. Wait before turning on your TV to avoid causing fire, electric shock, or component damage.

To attach the stand to the TV, first ensure the stand is assembled. Place a protective material (like a blanket, foam, or cloth) on the surface to prevent any damage. Carefully align the stand to the bottom of the TV and fasten it using the supplied screws.

To prepare your LCD TV for wall mounting, first remove the stand by unscrewing the screws holding the TV to the stand. Then, secure a UL listed wall mount bracket to the back of your TV using four screws. Follow the instructions provided with the wall mount bracket for installation. Ensure the TV is at least 2.36 inches (60 mm) from the wall to prevent cable interference.

To connect a digital audio device, use the LINE OUT jack on the TV. This will allow you to transmit audio signals from the TV to your digital audio device. Ensure that the device is properly connected and turned on, and then select the appropriate input source on the TV to play audio through the connected device.

To switch to the USB input mode, press the 'INPUT' button on the remote control and then select the USB input from the list.

To clean the screen, first unplug the power cord. Then, dust the TV by wiping the screen and the cabinet with a soft, clean cloth. If additional cleaning is needed, use a clean, damp cloth. Avoid using liquid cleaners or aerosol cleaners.