Haier LE40B650CF Instruction Manual

To record a program, you need to prepare to record the program, then record the program, and finally, play the recording. The specific steps for each of these actions are detailed in the manual under the sections 'Prepare to record the program', 'Record the program', and 'Play the recording'.

The EPG Menu stands for Electronic Program Guide. It allows you to view and navigate through the TV programming schedule. The EPG Menu is accessible on your Haier LE40B650CF TV and provides detailed information about the programs available on different channels. You can use it to plan your viewing or recording schedule.

To avoid damaging the LCD screen, do not put the TV set near sources of humidity, do not use any abrasive cleaners, and avoid contact with objects that may scratch the LCD screen.

Refer servicing to qualified service personnel. Do not remove the cabinet back from your set as high voltages are used in the operation of this television receiver.

To clean the screen and cabinet of your Haier LE40B650CF TV, first remove the power cable from the power socket. Then, wipe the TV with a soft, dry, dust-free cloth.

To change the input source, press the SOURCE button on the front control panel or the remote control to display the input source menu, then use the CH+ or CH- buttons to select the desired input source.

You can connect various external devices to your Haier LE40B650CF TV using the following interfaces: SCART, HDMI1, HDMI2, VGA, USB1, USB2, RF, AV, YPbPr, PC AUDIO, DIGITAL AUDIO OUTPUT (COAXIAL), and HEADPHONE. These interfaces allow you to connect devices such as audio/video machines, amplifiers, DVD players, and computers.

To connect a DVD player with YPbPr/YCbCr outputs to your Haier LE40B650CF TV, you will need to use the YPbPr interface. Connect the Green (Y), Blue (Pb/Cb), and Red (Pr/Cr) cables from the DVD player to the corresponding YPbPr inputs on the TV. Additionally, connect the White (AUDIO L) and Red (AUDIO R) audio cables to the corresponding audio inputs on the TV.

To record the program you are currently watching, press the REC Button. A red REC icon will appear on the screen, and the record time/length and remaining record time will be displayed in the menu below.

To set a specific time range for a movie, press the 'Left' or 'Right' key on the remote control to select the 'Set A' function, then press the 'OK' key. This will allow you to set the start and end times (A and B) for the movie to play in a loop within that time range.