Haier LE32C430 Owner's Manual

To change the channels, use the remote controller. Press the 'CH+' or 'CH-' buttons to navigate through the available channels.

If your TV does not turn on, check the power supply and ensure the TV is properly connected to a power source. If the issue persists, refer to the troubleshooting section on page 13 of the manual for further assistance.

No, you should not install the Haier LE32C430 near any heat sources such as radiators, stoves, or other apparatus that produce heat. This could potentially damage the TV or pose a safety risk.

If the power cord or plug is damaged, you should unplug the TV and refer all servicing to qualified service personnel. Do not attempt to repair it yourself.

Refer servicing to qualified service personnel. Do not attempt to remove the cabinet back from your set as high voltages are used in the operation of this television receiver.

You can connect your PC to the Haier LE32C430 TV using the Analog RGB (VGA) input or the High-Definition Multimedia Interface (HDMI) inputs. There are two HDMI ports available for high-definition connections.

If the remote control is not functioning properly, check the batteries. If they are exhausted, replace them with new ones. It is recommended to use alkaline batteries. Additionally, remove the batteries if the remote control is not to be used for a long time.

To delete a program, press the teletext red button to show the red delete cursor. Move the cursor to the program you want to delete, press the red button again, and the program will be deleted.

The TV is designed to auto sleep after 15 minutes of no signal. If you want to prevent this, you can adjust the settings in the TIME MENU, which is the fourth item in the MENU. You can set the sleep timer or other power settings to suit your preferences.

You can adjust the audio track, subtitle, or program by accessing the Info menu. Choose the Info icon and press OK to display the Info MENU, where you can make the necessary adjustments.