Haier LC-2710D Operating Instructions Manual

The HDMI input on the Haier LC-2710D television allows you to connect high-definition devices such as Blu-ray players, gaming consoles, or computers to enjoy high-quality audio and video.

For any problem, refer servicing to qualified service personnel. Do not attempt to open the TV or remove any covers, as there are no user-serviceable parts inside and it may pose a risk of electric shock.

If the remote control is not working properly, ensure there are no objects between the remote control and the remote sensor of the TV set. Also, avoid using the remote control in direct sunlight or other strong light sources, as this can interfere with the signal. Additionally, do not expose the remote control to direct heat or damp places, as this can potentially damage the remote.

If the TV set is in standby status, pressing the power switch on the remote control or TV set will turn the power on to the set.

To perform an auto search for TV channels, follow these steps: 1. Press the MENU button to select the source menu. 2. Use the CH+/- button to select AUTO SEARCH. 3. Press the VOL+/- button to start searching. 4. Press the MENU button to finish the auto search. Note that you usually only need to run the Auto Search function once, unless you change your cable provider.

To adjust the picture settings, follow these steps: 1. Press the MENU button to open the menu. 2. Use the CH+/- button to select the PICTURE menu. 3. Use the VOL+/- button to enter the PICTURE menu. 4. Use the CH+/- button to select the item you need to adjust (e.g., CONTRAST, BRIGHTNESS, SATURATION, etc.). 5. Use the VOL+/- button to adjust the selected item. 6. Press the MENU button to return to the last menu or exit the screen menu display.

To set the clock, press the MENU button to select the FUNCTION menu, then use the CH+/- button to select CLOCK. Use the VOL+/- button to enter the clock setting, and adjust the hour or minute with the CH+/- button. To set the timer functions (TIME ON and TIME OFF), follow similar steps by selecting the respective options and adjusting the time accordingly. Note that you must first set the system clock before setting other items.

Using the S-VIDEO input will provide better image quality compared to the AV input. To use the S-VIDEO input, connect the S terminal output on the source to the S terminal input on the TV set, and connect the S terminal left/right audio output on the source to the relevant port on the TV set. Then, press the TV/AV button repeatedly until the display mode is S-VIDEO and press the PLAY button on the source to start watching. For AV input, connect the audio video output port on the source to the AUDIO IN and VIDEO IN ports on the TV set, press the TV/AV button to select component VIDEO mode, and press the PLAY button on the source to start watching.

If you see artifacts or a little glitter when you first turn on your Haier LC-2710D TV, it is normal, especially if the temperature of the TV set is rather low. This should resolve itself as the TV warms up.

If there is no picture on your Haier LC-2710D TV, check the following: the direction and connection of the antenna, the power plug to ensure it is plugged into the AC outlet, and the main power to ensure it is turned on. Also, check the settings for contrast, brightness, and volume.