Haier LC-2610D Operating Instructions Manual

The HDMI input on the Haier LC-2610D television allows you to connect high-definition audio and video sources, such as Blu-ray players, gaming consoles, or streaming devices, to the TV for enhanced viewing experience.

To set up the remote control, refer to the 'Preparation for remote control' section on page 6 of the manual.

For any problems, refer to the qualified service personnel as mentioned in the caution section. Do not attempt to open or service the TV yourself to avoid the risk of electric shock.

If you hear abnormal sounds or smell something unusual from the unit, unplug it immediately and contact an authorized service provider.

When cleaning the unit, ensure it is unplugged. Use a soft cotton cloth and avoid using any abrasive cleansers. Prevent water from entering the set.

Press the VOL+/- button to adjust the volume.

To perform an auto search for available channels, press the MENU button to select the source menu, then press the CH+/- button to select AUTO SEARCH. Press the VOL+/- button to start the search and the MENU button to finish.

To recover a skipped channel number, press the direct number buttons to select the channel number that needs to be recovered. Then, press the MENU button to enter the source menu, press the CH+/- button to select SKIP, and press the VOL+/button to select OFF.

To adjust the noise reduction (DNR) on your Haier LC-2610D TV, press the MENU button to select the PICTURE menu. Then, use the CH+/- button to select DNR. Finally, use the VOL+/- button to choose between OFF, WEAK, or STRONG.

Check the direction, station, and connection of the antenna. Ensure that the antenna is properly aligned and connected to the TV.