Haier L26V6-A8K Owner's Manual

No, you should not open the back cover or remove any covers. There are no user-serviceable parts inside. If you need service, refer to qualified service personnel.

If the unit has been exposed to rain or water, or if liquid has been spilled into the unit, do not use it. Contact a qualified technician for service.

If the unit exhibits a distinct change in performance, this indicates a need for service. Do not attempt to adjust any controls that are not covered by the operating instructions, as improper adjustment may result in damage and will often require extensive work by a qualified technician to restore the unit to its normal operation.

To change the input source, press the 'TV/AV' button on the front control panel or use the corresponding button on your remote control.

The 'P-' and 'P+' buttons are used to change the program or channel. They can also be used to navigate menu options.

The effective receiving scope for the remote control signal is 8 meters to the front of the remote control window, and 45 degrees to the left or right side, and 20 degrees above or below the control window. Ensure the remote control is pointed toward the remote control window on the display and that there are no obstacles between them.

To watch digitally broadcast programs, you need to purchase and connect a digital set-top box to your Haier L26V6-A8K TV. Use the TV's YPbPr IN and AUDIO IN jacks, PC or HDMI/DVI VIDEO port for video connections, depending on your set-top box connections available. Then, make the corresponding audio connections. Turn on the digital set-top box, use the TV/AV button on the remote control to select HDMI mode, and press the Play button on the set-top box to start watching the program.

To connect headphones to the Haier L26V6-A8K TV, plug a set of headphones into the 3.5mm mini-jack socket located on the rear panel of the set. Note that when headphones are connected, you will not receive sound from the TV speakers.

To change the picture mode, press the P.STD button on your remote to select from the available options: Normal, Soft, Personal, or Bright. Each mode is designed for different lighting conditions.

To set a new password, press the H.LOCK button on the remote control. Enter the current password (default is 0000). If correct, the LOCK menu will appear. Use the CH+/- buttons to select 'Password' and the VOL+/- buttons to change it. Enter the new password twice to confirm.