Haier L26V6-A8 Owner's Manual

To turn on or off the Haier L26V6-A8 TV, you can use the Power On/Off function. This is detailed on page 9 of the manual.

To search for TV channels, you can use the Channel search function. This is detailed on page 11 of the manual.

If you hear an abnormal sound from the television, you should immediately disconnect the product from the power supply, keep it away from a transformer or heat source, and contact authorized after-sales service for assistance.

To change the input source, press the 'TV/AV' button on the front control panel. This will allow you to select between different input sources.

The 'MENU' button on the front control panel is used to display the menu options on the screen. You can navigate through the menu options using the 'P+' and 'P-' buttons.

To turn on the Haier L26V6-A8 television, first switch on the power supply. If the television screen does not light, press the Power button on the remote controller or the television itself.

If you receive excessive unwanted programs, it is recommended to use the manual search function. After the preset menu appears on the screen, press the VOL+ button on the remote controller to enter the manual search mode. Use the CH+/- button to change frequency bands and the VOL+ or VOL- buttons to scan channels up or down. The television will automatically save the desired program and stop scanning.

To swap programs, press the CH+/- button on the remote controller or television to access the 'Exchange' option in the preset menu. Then, press the VOL+ button to enter the submenu. Use the VOL-/+ or digit buttons to select the current program and the program you want to exchange. After confirming both programs, select the 'Exchange' option and press the VOL+ button to complete the swap.

When receiving VGA signals, the TV will automatically adjust the parameters. However, if the picture is not adjusting correctly, ensure that the input mode is set to YUV or D-SUB and follow the manual adjustment steps provided in the manual.

To set the timer for the TV to turn off at a specific time, follow these steps: 1. Press the Menu button on the television and the remote controller, then use the CH+/- buttons to navigate to the timer setup menu. 2. Ensure the clock is correctly calibrated. 3. Use the VOL+ and VOL- buttons to set the hour and minute for the off-time. 4. Press the Enter button to confirm the setting. The TV will turn off at the specified time.