Haier L26A6A-A1 Operating Instructions Manual

To turn on or off the TV, you can use the power button on the front control panel or the corresponding button on the remote controller.

To install the batteries in the remote controller, place the remote controller with the face down, open the cover of the battery compartment, insert two AA 1.5V batteries ensuring the cathode and anode match the markings, and then close the cover of the battery compartment.

If the remote controller is not working properly, ensure there are no objects between the remote controller and the remote sensor of the TV set. Avoid using the remote in direct sunlight or strong light, and do not place it in a hot, damp, or area where it can be struck. Additionally, ensure you are using two AA 1.5V batteries and that they are correctly inserted with the correct polarities.

To lock the TV and prevent children from changing the settings, press the 'Child lock' button (button 11).

You can press the VOL+/- button on the remote controller to adjust the volume.

To fine-tune the TV, press the MENU button to select the source menu. Then, use the CH+/- button to select FINE TUNE. Press the VOL+/- button to start fine-tuning until you get the best picture and sound. Release the button and press the MENU button to exit.

To adjust the sound balance and equalizer, press the MENU button to select the sound menu. Use the CH+/- button to select the sound item you need to set, and then use the VOL+/- button to adjust the selected item. For balance, press VOL+/- to enter adjustment and use VOL+/- to adjust the balance of left and right sound. For equalizer, press VOL+/- to enter the EQUALIZER set menu, use VOL+/- to select different frequencies, and use CH+/- to adjust.

To connect a VCR to the Haier L26A6A-A1 TV, connect the VCR's radio frequency input to the back radio frequency input of the TV. Then, connect the antenna to the VCR's antenna input. Press the TV/AV button on the TV to select TV mode, and then press the PLAY button on the VCR to start watching.

To use your Haier L26A6A-A1 TV as a computer display, follow these steps: 1. Connect the VGA output port of your computer to the VGA port on the TV. 2. Connect the audio cable from your computer to the VGA AUDIO IN port on the TV. 3. Press the TV/AV button on the TV remote to select VGA mode. 4. Turn on your computer, and the screen image should display on the TV.

If you see a little glitter or spots on the screen when you turn on the TV, it is normal and does not affect the display. This can happen if the temperature of the TV set is rather low. Additionally, it is normal to see a little red, green, and blue spot, or one bright dot or dark dot on the screen within the standard range.