Haier L24F6 User Manual

To turn on the Haier L24F6 TV, you can either press the 'Power' button on the panel control keys or use the 'Power' button on the remote control.

If your TV is not displaying any picture, you can try the following steps: 1. Check if the TV is properly connected to a power source. 2. Ensure that the correct signal source is selected. 3. Verify that the input source (e.g., HDMI, AV) is correctly set. 4. If the issue persists, refer to the 'Simple troubleshooting' section in the manual for further assistance.

You can connect your DVD player to the Haier L24F6 monitor using the AV-OUT connection. Connect the audio or video output end of the DVD player to the monitor using the appropriate AV cables.

Yes, you can connect a game machine to the Haier L24F6 monitor. Use the AV-OUT connection to link the audio or video output end of the game machine to the monitor.

To connect a DVD player with YPbPr/YCbCr output to the Haier L24F6 TV, connect the YPbPr or YCbCr output of the DVD player to the corresponding YPbPr/YCbCr input on the TV. For better picture quality, also connect the audio output of the DVD player to the TV's audio input. Ensure that the signal source selection on the TV is set to YPbPr pattern.

To adjust the volume, use the VOL+ and VOL- keys on the panel control. Pressing VOL+ will increase the volume, while pressing VOL- will decrease it. These keys can also be used to adjust the analog value under OSD (On-Screen Display) operation.

To turn on or off the TV, press the POWER button on the remote control.

To mute the sound, press the MUTE button on the remote control.

To turn on the Haier L24F6 TV, plug the power cord into the electrical socket, then press the 'Power' button on the right side lower part of the back cover, or press the 'Power' key on the front panel, or use the 'Power' key on the remote control.

The TV will automatically go into standby mode if there is no signal input for 5 minutes after turning on, or if the preset time for turning off is reached. If you do not plan to use the TV for a long time, it is recommended to turn off the power supply completely instead of leaving it in standby mode.