Haier L1509-A User Manual

If water comes in contact with the LCD-TV, immediately disconnect the power cord from the power source, then wipe the set with a dry soft cloth.

Allow enough space for proper ventilation and do not place the unit in direct sunlight or near heat sources. Also, do not place the unit on unstable, dusty, and humid places.

To switch between different input signals, use the TV/AV button on the front panel. This will allow you to select from options such as PC, COMPONENT, TV, SCART, SVIDEO, or HDMI.

The VOL- and VOL+ buttons are used to adjust the volume. VOL- decreases the volume, while VOL+ increases it. Additionally, these buttons can be used to navigate left and right in the on-screen display (OSD) menu, and the VOL+ button can also be pressed to enter a selected item.

To adjust the volume, use the Volume down (V-) and Volume up (V+) buttons on the remote control. These buttons will allow you to increase or decrease the volume as needed.

To turn on the Haier L1509-A LCD-TV, first switch on the power button on the back of the set. The TV will go into standby mode. Then, press the POWER button on the remote control to turn on the TV. The indicator light on the front of the LCD-TV will change from red to green.

To switch among different input modes (PC, COMPONENT, HDMI, TV, SCART, SVIDEO) on the Haier L1509-A LCD-TV, press the TV/AV button on the remote control. Each press will cycle through the different input modes in the specified order. The display of the input mode will disappear after about 8 seconds.

To adjust the picture quality settings, press the MENU button and use the V+/V- buttons to navigate to the Picture menu. Use the P+/P- buttons to select the desired option, such as Brightness, Contrast, or Sharpness, and then use the V+/V- buttons to make changes to the parameters. Press the OK button to exit the menu once you have made your adjustments.

To change the display mode, press the MENU button and use the V+/V- buttons to navigate to the FUNCTION menu. Select DISPLAY MODE and use the P+/P- buttons to choose between 4:3 and FULL SCREEN.

To skip a channel, press V+/V- to select ON in the SKIP menu. This channel will be skipped the next time you press P+/P-. You can still select the channel by pressing the digits button. To restore the channel, select OFF in the SKIP menu.