Haier KXT7020BK Instruction Manual

To connect the Haier KXT7020BK, refer to the instructions provided on page 6 of the manual.

For general troubleshooting, refer to the instructions provided on page 13 of the manual.

The AV/TV Switch allows you to toggle between TV and AV (Audio/Video) inputs. This is useful when you want to switch between watching regular TV broadcasts and using external AV equipment connected to the TV, such as a VCD or DVD player.

To connect an antenna, plug it into the ANT jack (13). The unit can receive CATV/ANT signals from this input.

To turn on and off the Haier KXT7020BK TV, press the POWER button on the unit or the remote control. The power light should be red when the unit is plugged in.

To adjust the picture settings, press the MENU button on the unit or the PIC button on the remote to enter the PICTURE screen. Use the CH up or CH down buttons to scroll through options like BRIGHT, CONTRAST, COLOR, and TINT. Use the VOL up or VOL down buttons to adjust each option.

To add or delete a channel, navigate to the desired channel using the PROG button. To delete a channel, press the VOL up or VOL down button until the SKIP function reads 'ON'. To add a channel, press the VOL up or VOL down button until the SKIP feature reads 'OFF'.

Check the connection of the AC adaptor or car adaptor. Ensure the batteries are not run down or installed incorrectly.

The brightness and contrast settings might be too low. Adjust these settings in the TV menu. Additionally, ensure the TV antenna is properly adjusted and that the reception is strong. If the issue persists, try relocating the TV to a place with better reception.