8Electrical connection 220-240V~50/60HzPower 700WHaier Spares and ConsumablesAlways replace parts with genuine Haier spares.These are available from your local Haier dealeror direct from Haier. When ordering partsalways quote your model number.QualityHaier’s factories have been independentlyassessed for quality. Our products are madeusing a quality system which meets therequirements of ISO 9001.Your GuaranteeThe guarantee conditions for this appliance areas defined by our representative in the countryin which it is sold. Details regarding theseconditions can be obtained from the dealer fromwhom the appliance was purchased. The bill ofsale or receipt must be produced when makingany claim under the terms of this guarantee.7. Technical data8. Important informationRefer to image 15 to clean your product. [15]• Before cleaning the main product, pleaseunplug it.• Do not use abrasive chemicals, metal objectsor hard brushes to clean the appliance.• Remove the frother from the jug.• The cleaning brush delivered with theappliance is recommended to be used.• Never wash the jug in the dishwasher.• Make sure the connector and the recessedareas are clean and dry before next use.5. Cleaning & Maintenance6. TroubleshootingDrink overflow» Cause 1: Milk or water exceed the Max level.» Cause 2: The jug inner has scale or is not clean.• Solution: Ensure the milk and water doesnot exceed the max level (Max water350ml, Max milk 210ml). Clean jug inner,ensure it is clean. [3]Temperature sensor Error (All lights blinkingfor 5 seconds, and an audible beep sounds 3times)» Cause 1: The jug not in the base but drinkfunction selected.» Cause 2: The temperature sensor has shortcircuited.• Solution: Ensure the jug is placed in themain product.If the problem persists contact CustomerService.Frother error (Left 3 lights blinking for 5seconds, and an audible beep sounds 3 times.)» Cause 1: The ingredients are too large andhave jammed the frother.» Cause 2: Agitator motor broken.• Solution: Remove all ingredients in thefrother and clean thoroughly, ensure theingredient is cut into pieces less than5*5mm.If the problem persists contact CustomerService.Heating element error (Right 4 lights blinkingfor 5 seconds, and an audible beep sounds 3times.)» Cause: Heating element broken.• Solution: Contact Customer Service.GB