To turn on the Haier HLT10 TV, locate the power button on the TV or the remote control and press it. The TV should power on and display the initial screen.

If the Haier HLT10 TV does not turn on, first check if the power cord is properly connected to both the TV and the power source. Ensure the power outlet is functioning by testing it with another device. If the issue persists, consult the troubleshooting section of the manual or contact customer support.

If the TV set has no picture and no sound, check if the AC adaptor is properly connected or if the battery power is low. If the battery power is low, replace the batteries and try again.

The maximum power output for the earphone jack is ≥250mW.

The resolution of the display screen is 800(RGB) * 480.

To start scanning for programs, press the ENTER button.

To switch the display mode, use the SCALE button on the remote control. This will toggle the display between 16:9 and 4:3 modes.

To set the caption mode, press the up or down button to select 'CC' and then press the ENTER button to enter the setting page. Use the left or right buttons to set the caption mode as Off, On, or CC On Mute.

To display the current program information, such as the channel number, soundtrack mode, subtitle language, and more, press the INFO button on your remote.

To set the caption mode, press the CC button on the remote control. The screen will display the available options. Use the left or right buttons to select 'YES' and press the enter button to start scanning the channels. The available channels will be memorized automatically. You can keep pressing the CC button to select different items as desired. The options are: Off, On, CC On Mute.