Haier HLH26BBTV Operating Instructions Manual

To set up the remote control, refer to the 'Preparation for remote control' section on page 7 of the manual.

For any problem, refer to the 'Basic operation' section on page 9 of the manual. If the issue persists, refer servicing to qualified service personnel as there are no user-serviceable parts inside the product.

If you hear any abnormal sounds or smell anything unusual from the unit, unplug it immediately and contact an authorized service provider.

To turn the device on and off, use the Power On/Off Button located on the front control panel.

If the device does not operate normally, unplug it and refer all servicing to qualified service personnel. Do not attempt to service the device yourself.

If the TV set is in standby status, pressing the power switch on the remote control or TV set will turn the power on to the set.

Pressing the RECALL button can switch the channel to the last channel you watched.

To adjust the picture settings, press the MENU button to open the menu. Use the CH+/- button to select the 'PICTURE' menu and then use the VOL+/- button to enter. Use the CH+/- button to select the specific setting you want to adjust (e.g., CONTRAST, BRIGHTNESS, SATURATION, etc.) and the VOL+/- button to make the adjustment. Press the MENU button to return to the previous menu or exit the screen menu display.

To perform an auto search for TV channels, press the MENU button to select the source menu. Use the CH+/- button to select 'AUTO SEARCH' and then press the VOL+/- button to start the search. Press the MENU button to finish the auto search. Note that you will only need to run the Auto Search function once unless you change your cable provider.

To recover a skipped channel number, press the direct number buttons to select the channel number that needs to be recovered. Then, press the MENU button to enter the source menu, use the CH+/- button to select SKIP, and press the VOL+/button to select OFF.