Haier HL46XSL2 Service Manual

To connect external equipment to your Haier HL46XSL2 TV, refer to the 'External Equipment Connections' section in Chapter 5 of the service manual. This section provides detailed instructions on how to properly connect various external devices.

The resolution of the Haier HL46XSL2 is 1920x1080 pixels.

To access the on-screen menu, press the MENU button on the side panel of the TV.

To change the input source, press the INPUT button on the side panel repeatedly until you select the desired source. In the MENU screen, the INPUT button also serves as the ENTER button.

To enter the Service Mode, press the 'menu' button, then input '8893'. The system will enter the factory mode menu.

In the factory mode menu, use the up/down buttons to select 'RESET ALL', then press the 'OK' button. After the reset, shut off the power. Be careful when using this function as it will return all settings to the factory state.

First, verify if the television is properly plugged in and supplied with power. Check if electricity is available. If the issue persists, press the INPUT button to change the signal input to TV input and restart the television. Additionally, check if the Mute mode is set by pressing the Mute button, and try switching to another channel to see if the problem occurs there as well. You can also press the VOL+ button to see if the problem can be solved.

To troubleshoot poor sound, verify if the sound system is set correctly. Refer to the relevant chapter in the manual for adjustments.

A horizontal gray line on the screen of the Haier HL46XSL2 can be caused by a failure in the TCP (Tape Carrier Package) or a misalignment between the TCP and the LCD panel.

A vertical color line on the Haier HL46XSL2 screen can be due to a panel failure, specifically a misalignment between the TCP and the LCD panel, or something electrical entering the panel. It is recommended to check the ACF bonding for any shorts and inspect the TCP for any cracks or damage.