Haier HL26B-A Owner's Manual

No, you should not install the Haier HL26B-A near any heat sources such as radiators, heat registers, stoves, or other apparatus that produce heat.

If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Do not defeat the safety purpose of the polarized or grounding-type plug.

To connect an S-Video device to the TV, use the S-Video input port on the back panel. Connect the S-Video cable from the device to the S-Video input on the TV. Note that in standby mode, these ports will not work.

If the picture quality is poor due to a weak signal, consider purchasing a signal amplifier and installing it properly. If you need to split the antenna signal for two TVs, install a 2-Way Signal Splitter in the connections. For professional installation, contact a professional in your area.

To connect your DVD player to the TV for better picture quality, use the component input ports. Connect the DVD video outputs (COMPONENT) to the Y Pb Pr jacks on the TV and the DVD audio outputs to the Y Pb Pr Audio IN jacks on the TV. If your DVD player only has an S-VIDEO output jack, connect this to the S-VIDEO input on the TV.

If there is noise in the picture, change the PC mode to another resolution, change the refresh rate to another rate, or adjust the brightness and contrast on the menu until the picture is clear. If the refresh rate of the PC graphic card cannot be changed, consider changing the PC graphic card or consulting the manufacturer of the PC graphic card.

To connect headphones to the Haier HL26B-A TV, plug a set of headphones into the 3.5mm mini-jack socket located on the side panel of the set. Note that when headphones are connected, you will not receive sound from the TV speakers.

To change the language of the on-screen display (OSD) menu, follow these steps: 1. Choose the TV Input and then press the MENU button. 2. Press the / button to select the Function menu. 3. Press the or OK button and then select the Menu Language. 4. Press the or OK button to select your preferred language (English, Spanish, or French). 5. Press the EXIT button to return to normal viewing or press the MENU button to return to the previous menu.

To add a new channel without clearing the existing ones, follow these steps: 1. Press the MENU button and then select the Channel menu. 2. Press the or OK button and then use / button to select Tuner. 3. Press the or OK button to select Cable or Antenna mode. 4. Press the / button to select Add Channel Scan. 5. Press the or OK button to start searching. 6. To cancel searching, press the EXIT/MENU button.

To adjust the DNR settings, press the MENU button and use the / button to select the Function menu. Then, press the or OK button and use the / button to select DNR. Press the or OK button to choose between Off, Weak, Medium, or Strong.