Haier H55S90EU Owner's Manual

Please refer to the 'Wall Mount Installation' section on page 5 of the manual for detailed instructions on how to install the Haier H55S90EU on the wall.

The operating instructions for the Haier H55S90EU can be found in the 'Operation' section on pages 10-20 of the manual.

To avoid any injury caused by the product leaning, ensure that the entire product is placed within the table surface in a horizontal position.

Refer servicing to qualified service personnel. Do not attempt to remove the cabinet back from your set as high voltages are used in the operation of this television receiver.

Do not expose the television receiver to rain or moisture. Additionally, do not block the ventilation holes in the back cover and avoid exposing the television to direct sunlight and other sources of heat.

The Haier H55S90EU TV has multiple input options. You can connect external devices using the following interfaces: HDMI x 4, Composite Video Input x 1, Audio Input x 1, USB x 2, OPTICAL OUTPUT x 1, HEADPHONE OUTPUT x 1, RF x 1, LNB IN x 1, and CI x 1.

To connect a VCR or DVD player to the Haier H55S90EU TV, use the AV input terminals on the rear of the TV. Connect the yellow (Y) cable to the video output of the device, the red (R) cable to the audio right (R) output, and the white (W) cable to the audio left (L) output of the device.

If the TV does not display the video from a connected device via HDMI, ensure that the device is set to output a standard HDMI signal. If the device is outputting a DVI signal, the 'AV Audio' channel on the TV will change to receive the audio for the HDMI port. Additionally, check if the device is supplying a non-standard signal, as this might cause compatibility issues.

To turn off HDMI devices with the TV, navigate with the keys to enter the sub-menu for Device auto power off. After enabling this feature, HDMI devices will turn off with the TV.

To connect your Haier H55S90EU TV to a WiFi network, go to the 'Settings' menu, navigate to 'Network & Internet', and press OK. Select the desired WiFi network from the available options and press OK. You may need to input the password for the WiFi network.