Haier GE UVC9420 Installation Instructions Manual

49-2000930 Rev. 1 9InstallationInstructionsIf you have questions, call GE Appliances at 800.GE.CARES (800.432.2737)or visit our website at: GEAppliances.com. In Canada, visit GEAppliances.ca or call 800.561.3344.INSTALLATION INSTRUCTIONSBEFORE YOU BEGINRead these instructions completely andcarefully.IMPORTANT — Save theseinstructions for local inspector’s use.IMPORTANT — Observe all governingcodes and ordinances.Note to Installer – Be sure to leave theseinstructions with the Consumer.Note to Consumer – Keep these instructions forfuture reference.Skill level – Installation of this vent hood requiresbasic mechanical and electrical skills.Completion time – Approximately 1 to 3 hoursProper installation is the responsibility of theinstaller.Product failure due to improper installation is notcovered under the Warranty.FOR YOUR SAFETYBefore beginning the installation,switch power off at service panel and lock theservice disconnecting means to prevent power frombeing switched on accidentally. When the servicedisconnecting means cannot be locked, securelyfasten a prominent warning device, such as a tag, tothe service panel.Due to the weight and size of thesevent hoods and to reduce the risk of personal injuryor damage to the product, TWO PEOPLE AREREQUIRED FOR PROPER INSTALLATION.Disconnect all electrical power atthe main circuit breaker or fuse box before installing.TO REDUCE THE RISK OF FIRE,ELECTRIC SHOCK OR INJURY TO PERSONS,OBSERVE THE FOLLOWING:A. Installation work and electrical wiring must bedone by qualified person(s) in accordance withall applicable codes and standards, includingfire-rated construction.B. Sufficient air is needed for proper combustionand exhausting of gases through the flue(chimney) of fuel burning equipment to preventback drafting. Follow the heating equipmentmanufacturer’s guidelines and safety standardssuch as those published by the National FireProtection Association (NFPA), the AmericanSociety for Heating, Refrigeration and AirConditioning Engineers (ASHRAE) and the localcode authorities.C. When cutting or drilling into wall or ceiling, donot damage electrical wiring and other hiddenutilities.D. Ducted fans must always be vented to theoutdoors.E. Turn off breaker to adjacent rooms while working.TO REDUCE THE RISK OF FIRE,USE ONLY METAL DUCT WORK.Custom Insert HoodUVC9420, UVC9480