Haier 75UF5550B Service Manual

Also see for 75UF5550: Service manual

Contents

Table of Contents2

Chapter 1. 1. 1. 1. General4

Chapter 2. 2. 2. 2. Speci9

Chapter 4. 4. 4. 4. Location14

Haier 75UF5550B Service Manual Manual pdf 20 page image

Service ManualModelModelModelModel No.:No.:No.:No.: 75UF555075UF555075UF555075UF5550-2.-2.-2.-2. ExternalExternalExternalExternal EquipmentEquipmentEquipmentEquipment ConnectionsConnectionsConnectionsConnectionstennatennantennantenna ConnectionConnectionConnectionConnectionConnect your aerial to the back of the TV into theANTENNA IN socket.I proveI proveI proveI prove YourYourYourYour SignalSignalSignalSignalTo improve picture quality in a poor signal area, use asignal amplifier (not supplied).nnectnnectonnectonnect YourYourYourYour PCPCPCPC totototo thethethethe TVTVTVTVConnectConnectConnectConnect aaaa DVDDVDDVDDVD PlayerPlayerPlayerPlayer orororor VCRVCRVCRVCR totototoYourYourYourYour TVTVTVTVThere are two ways in which you can connect a DVDplayer or VCR to your TV. Make sure that both the TVand DVD player or VCR are switched off before youconnect them.HDMIHDMIHDMIHDMI InputInputInputInputYou can use your TV as a monitor for your personalcomputer by connecting it with a VGA cable (notsupplied).A Connect the cable from the HDMI device to the TVHDMI socket.Read your computer user guide and check it has aVGA connector.Turn off your TV and PC.BCPress the SOURCESOURCESOURCESOURCE button to select HDMI mode.Refer to the HDMI device user guide for how tooperate.Connect a D type 15-pin VGA interface cable to theNote：The TV have no VGA.VGA video interface connector on the PC. Connectthe other end of the cable to the PC interfaceconnector on the TV. Tighten the screws on theVGA connectors and connect the audio cable (notsupplied) to the audio input socket on the back of theTV.Turn on the TV firstly and then the PC.Press the Source button on the TV or TV remotecontrol to set the video input mode to PC.F Once the image shows, if there is noise present,change the PC mode to other resolutions, change therefresh rate to other rate or adjust the brightness andcontrast on the menu until the picture is clear.nnectnnectonnectonnect aaaa DVDDVDDVDDVD PlayerPlayerPlayerPlayer totototo YourYourYourYour TVTVTVTVConnect the DVD video outputs (Y, Pb, Pr) to theCOMPONENT (Y, Pb, Pr) IN socket on your TV.Turn on the DVD player and insert a DVD disk.Press the SOURCE button to select COMPONENTmode.Refer to the DVD player user guide for operatinginstructions.19191919

/ 53

Questions and answers

Heed help?

Ask question about this manual

Related manuals for Haier 75UF5550