Haier 65UGX3500 User Manual

If the TV starts to overheat, unplug it immediately. Ensure that no vents or openings are covered or blocked, as inadequate ventilation can cause overheating. Also, avoid placing the TV in confined spaces or in a box while using it.

If the TV malfunctions, such as no video or audio, or if there is smoke or a bad odor, unplug the TV immediately. Do not attempt to fix it yourself; contact a service personnel for assistance.

No, you should not install the TV near any heat sources such as radiators, heat registers, stoves, or other apparatus that produce heat. This could potentially damage the TV.

To turn on the Haier 65UGX3500 TV, follow the instructions provided in the 'TURNING ON THE TV' section on page 7 of the user manual.

To connect an external audio/video device, you can use an HDMI cable (best), component cables (better), or a composite cable (good). Connect the appropriate cable to the corresponding jack on the TV (e.g., HDMI, COMPONENT, or COMPOSITE) and the device. Then, turn on both the TV and the device, press the INPUT button on the remote to open the input source list, highlight the correct input, and press OK to switch.

If the TV is not displaying the video from the connected external device, ensure that both the TV and the device are turned on. Press the INPUT button on the remote to open the input source list, highlight the input to which the device is connected (e.g., HDMI1, HDMI2, HDMI3, HDMI4, COMPOSITE, or COMPONENT), and press OK to switch. Make sure the cables are properly connected and that the device is set to output to the correct input.

To switch to the USB input, press the 'INPUT' button on the remote control, then select the USB input from the list.

To adjust the volume, use the 'VOL+' or 'VOL-' buttons on the remote control.

The Canada English rating levels available on the Haier 65UGX3500 include TV-Y, TV-Y7, TV-G, TV-PG, TV-14, and TV-MA. These ratings are used for programs in the English rating system and can be locked or unlocked to control the content viewed.

To play music from a USB device, connect the USB device to the USB port on the rear of the TV. Press INPUT and select USB, or press USB on the remote control to switch to USB input. Highlight 'Music' and press OK. Select the music file you want to play and press OK. Use the navigation buttons to control playback.