Haier 65UF2505 User Manual

When replacing the batteries in your Haier 65UF2505 TV, ensure that you replace them with the same or equivalent type. Avoid exposing the batteries to excessive heat, such as direct sunlight or fire, as this could pose a risk of explosion.

If the TV starts to overheat, unplug it immediately. Ensure that no vents or openings are covered or blocked, as inadequate ventilation can cause overheating. Also, avoid placing the TV in direct sunlight, dusty, humid, or smoky areas.

It is recommended to call service personnel to clean the internal part of the TV once a year.

If the power-supply cord or plug is damaged, you should unplug the TV and refer all servicing to qualified service personnel. Do not attempt to repair it yourself.

When moving your TV from an area of low temperature to an area of high temperature, condensation may form in the housing. Wait before turning on your TV to avoid causing fire, electric shock, or component damage.

If the TV screen is not responding to touch, ensure that no pressure is applied to the screen display, as this may compromise the integrity of the display. Additionally, check that the TV is placed in a position to allow free airflow and that no heat sources, direct sunlight, or water are near the TV.

To change the input source, press the INPUT button on the side control. Then, use the VOL+ button to cycle through the available input sources until you reach the desired one.

To connect an external audio/video device, you can use an HDMI cable (best), component cables (better), or a composite cable (good). Connect the appropriate cable to the corresponding jack on the TV (e.g., HDMI, COMPONENT, or COMPOSITE). Then, follow the steps to switch the input source on the TV.

To play content from a device connected to the HDMI2 input, turn on both the TV and the connected device. Then, press the INPUT button on the TV remote to open the input source list. Highlight HDMI2 and press OK to switch to that input source.

To set the U.S. rating limits, you can use the 'US Rating' function. This allows you to set age-based and content-based ratings to control what content can be viewed. For example, you can set it to 'PG' to suggest parental guidance for children under 17.