Haier 55UGX3500 User Manual

Unplug the TV immediately and contact service personnel for assistance.

If your TV is not operating normally, unplug the power cord and refer all servicing to qualified service personnel.

The model number and serial number are located on the label at the back of the unit.

Staple your receipt to this manual. You will need it to obtain warranty service.

To turn on your Haier 55UGX3500 TV, first ensure that the stand is properly assembled and attached to the bottom of the TV. Place the TV on a solid surface. Connect the antenna cable or cable TV cable to the ANT IN aerial socket on the back of the TV set. Insert the supplied batteries into the remote control and use it to power on the TV.

The HDMI4(MHL) port is MHL enabled. You can connect an antenna or cable TV cable to this jack.

To set up your TV for analog and digital broadcasting signals, go to the initial setup menu. Select 'Air' as the signal type to receive both analog and digital (ATSC) broadcasting signals.

Check if the TV’s AC power cord is plugged into the outlet. Unplug the TV, wait for 60 seconds, then reinsert the plug into the outlet and turn on the TV again.