Haier 55UFC2500 User Manual

The steps for preparing your LCD TV for wall mounting are detailed in the 'PREPARING YOUR LCD TV FOR WALL MOUNTING' section of the manual.

To play content from an external device, turn on both the TV and the connected device. Press the INPUT button on your remote to open the input source list. Highlight the input corresponding to where the device is connected (e.g., HDMI1, HDMI2, HDMI3, HDMI4(MHL), Composite, Component) and press OK to switch to that input.

You can adjust the volume level by pressing the VOL+ or VOL- buttons on your remote control.

To set up your Haier 55UFC2500 TV for analog and digital broadcasting signals, go to the initial setup menu and select 'Air' as the signal type. This will allow the TV to receive both analog and digital (ATSC) broadcasting signals.

To set the signal type to receive digital broadcasting signals, go to the 'Air/Cable' setting and select 'Air'. This allows the TV to receive both analog and digital (ATSC) broadcasting signals.

To set the U.S. rating limits, navigate to the 'US Rating' option in the setup menu and select the desired age-based or content-based ratings.

When a rating is locked, that rating and all other higher ratings are also locked. Conversely, when a rating is unlocked, that rating and all lower ratings are unlocked.

To play music from a USB device, connect the USB device to the USB port on the rear of the TV. Press INPUT and select USB, or press USB on the remote control to switch to USB input. Highlight 'Music' and press OK. Select the song you want to play and press OK.

The power consumption of the Haier 55UFC2500 TV is 120W.