Haier 50D3505B User Manual

When replacing the batteries in your Haier 50D3505B TV, ensure that you replace them with the same or equivalent type. Avoid exposing the batteries to excessive heat, such as direct sunlight or fire, as this can pose a risk of explosion.

If the TV starts to overheat, unplug it immediately. Ensure that no vents or openings are blocked and that the TV is placed on an even surface. Avoid placing the TV in confined spaces or in direct sunlight, dusty, humid, or smoky areas.

If the TV malfunctions, such as no video or audio, or if there is smoke and a bad odor, unplug the TV immediately and contact a service personnel for assistance.

The model and serial number are located on the label on the back of the unit.

To turn on the Haier 50D3505B TV, follow the instructions provided in the 'TURNING ON THE TV' section on page 7 of the user manual.

To connect a digital audio device, use the LINE OUT port on the TV. This port is designed to carry digital audio signals, ensuring high-quality sound output.

To switch to the USB input mode, press the 'INPUT' button on the remote control and then select the USB input from the list.

To adjust the volume, use the 'VOL+' or 'VOL-' buttons on the remote control to increase or decrease the volume level.

To set the signal type to receive analog and digital (ATSC) broadcasting signals, go to the initial setup and select 'Air' as the signal type. This will allow the TV to receive both analog and digital (ATSC) broadcasting signals.

To change the repeat mode, select the repeat mode option and choose between Repeat One, Repeat ALL, or None.