Haier 21FA1 Owner's Manual

To clean the TV set, first pull out the power plug from the AC outlet. Use a dry cotton cloth to clean the cabinet and the screen. Avoid using benzene, petrol, or other chemicals, as well as hard cloths, to prevent damage to the screen.

If there is a severe thunder and lightning storm, it is recommended that you disconnect the TV set from the AC power outlet and remove the aerial plug to prevent any potential damage.

To switch between TV and AV modes, use the TV/AV switch button located on the front or side panel of the TV set.

To adjust the volume, use the VOL- (Volume down) and VOL+ (Volume up) buttons located on the front or side panel of the TV set.

To switch between TV and AV modes, press the 'TV/AV' button on the front panel of the TV set.

If the colour or sound of a channel is abnormal, the settings of the colour system or the sound system may be incorrect. Press the TUNE button to display the setting menu on the screen. Use the CH+/- buttons to select 'Colour' or 'Sound', then use the VOL-/+ buttons to select the appropriate system. Press the EXIT button to save the setting.

To quickly switch between the last two channels, press the SWAP button. This will toggle between the channel you are currently watching and the last channel you watched.

To automatically scan through all the programs, press the SCAN button. The TV will display each channel for about 2 seconds. To stop the scan, press the SCAN button again.

To perform a semi-automatic search for channels, follow these steps: 1. Press the CH+/- buttons or PROGRAM NUMBER 0-9 buttons to choose the desired channel. 2. Press the TUNE menu button until the TUNING menu appears on the right display. 3. Press the CH+/- buttons to select 'SEARCH'. 4. Use the VOL-/+ buttons to start searching for channels. The VOL- button is used for the lower side program search, and the VOL+ button is used for the higher side program search. Repeat this step until you find the desired channel.

To turn off the on-screen menu, you can either wait for it to disappear automatically within 15 seconds or press the EXIT button to eliminate the contents immediately.