Chapter 2: Getting Started www.gateway.com222 Assemble the left and right chassis latches using the special chassis latchscrews. Make sure that the latch is orientated as shown in the followingillustration, with the spring arm located against its stop (on the right sideat the top, on the left side at the bottom).3 Assemble to brackets to the rack as follows:a Fit the location pin at the back of the rail into the rear rail post.b Extend the rail to fit between the front and rear rack posts.c Attach the rail to both the front and rear of the rack using thewashers and screws supplied. The screws should be left looseenough to allow for sideways movement of the rail.d Tighten the two clamping screws.
