Garmin GPS 95 STD Personal Navigator Owner's Manual

Contents

Garmin GPS 95 STD Personal Navigator Owner's Manual Manual pdf 52 page image

7-2You may capture and save your position as a waypoint, without adding it toa route, by leaving the route storage number field blank.To capture present position ...· Press AUTOSTO. The pre-assigned waypoint identifier and capturedposition are displayed. (NOTE: The Autostore TM location is capturedas soon as you press AUTOSTO. This allows you all the time you needto change the waypoint identifier and/or confirm the Autostore TMoperation.)· If you wish to assign a different identifier to the waypoint: move thecursor to the waypoint identifier field, enter the name of your choice andpress ENT. If you enter a waypoint identifier already used, you will beinformed with the message, “WPT Exists _____” (where the blank willbe filled in with the waypoint identifier). Enter a different identifier if thisoccurs.· Press ENT on a blank route storage number field to save the waypoint.(If the route storage number field is not blank, the waypoint will beadded to the route shown.)7.2 BUILDING ROUTES WITH AUTOSTORETMThe GPS 95’s Autostore TM feature may also be used to build a route as youare flying. During your flight; as you reach each airport, NAVAID, landmark,or turn to a new heading; you may capture your position and add it to a route.Once you reach your destination you can then invert the route and follow thesame course back to where you started. Or, you may want the route for futurereference if you wish to make the same flight again.