Menu
Gardco PureForm P26 Quick Strat Manual
   |
1/29/2019 page 2 www.gardcolighting.com PN 442294663261 Rev APole with Tenon (See Table)TENON HEIGHTFITTERTYPEPTF2PTF3PTF4"X"DIA. (Ø)3-1/2"4-1/2"5"2-3/8" TO 2-1/2" O.D. X 4" HIGH3" TO 3-1/2" O.D. X 6" HIGH3-1/2" TO 4" O.D. X 6" HIGHUSED ON TENON SIZEFIG. 31. Open Arm Cover by loosening (2) #8-32 Phillips Pan Head Screws located on bottom of mounting arm (screws are captive and will re-main on door). Door is attached to arm with a safety cable and can be removed if necessary. (See Fig. 1 & 2)2. Attach luminaire/arm assembly to Pole Top Fitter by lining up the threaded hole on PTF to bottom hole on Arm.3. Thread the bottom 3/8” bolt, lock washer, and flat washer into the lower tapped hole of the PTF from the inside of arm assembly andtighten. (See Fig. 1,2 & 4)4. Pass the top 3/8” bolt, lock washer, and flat washer through the arm and into the top hole of the PTF. Secure with 3/8” lock washerand hex nut. Torque both bolts to approximately 45 FT.-LBS.5. Install the Pole Top Fitter/Luminaire onto the Tenon. Top of the tenon must seat against the fitter stop. Level and secure with (8) 3/8”socket set screws. Torque to approximately 20 FT.-LBS.6. Install strain relief rod through two holes in top of fitter, and route supply and ground wires over the strain relief rod. Tie off with tapeor wire tie as shown.7. Connect field supply and ground wires to luminaire leads. Make wire connections per NEC or applicable local codes. Secure with wiretie.8. Install PTF Cap and secure in place with (2) #10-32 Phillips Pan Head Screws.9. Install Photo Control in housing if used.10. Close Arm Assembly Cover and secure with (2) #8-32 Phillips Pan Head Screws.11. Apply a bead of suitable weatherproof sealant to horizontal top, vertical left and right edges of Arm where it contacts the pole to pre-vent water entry. (See Figure 5)12. Energize Luminaire to test installation.FIG. 4PTF2 PTF3/PTF4PureForm & EcoForm Luminaire Mounted on PTF2 (3-1/2” O.D.),PTF3 (4-1/2” O.D.) or PTF4 (5.00” O.D.) Pole Top Fitter |
Related manuals for Gardco EcoForm ECF2
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved