GE KTD-400 User Manual

GE KTD-400 User Manual Manual pdf 2 page image

Copyright Copyright © 2006, GE Security Inc. All rights reserved.This document may not be copied or otherwise reproduced, in whole or in part, except asspecifically permitted under US and international copyright law, without the prior writtenconsent from GE.Document number/ 1034790E (March 2006).Disclaimer THE INFORMATION IN THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. GE ASSUMESNO RESPONSIBILITY FOR INACCURACIES OR OMISSIONS AND SPECIFICALLY DISCLAIMS ANYLIABILITIES, LOSSES, OR RISKS, PERSONAL OR OTHERWISE, INCURRED AS A CONSEQUENCE,DIRECTLY OR INDIRECTLY, OF THE USE OR APPLICATION OF ANY OF THE CONTENTS OF THISDOCUMENT. FOR THE LATEST DOCUMENTATION, CONTACT YOUR LOCAL SUPPLIER OR VISIT USONLINE AT WWW.GESECURITY.COM.This publication may contain examples of screen captures and reports used in daily operations.Examples may include fictitious names of individuals and companies. Any similarity to namesand addresses of actual businesses or persons is entirely coincidental.Trademarks and patents GE and the GE monogram are registered trademarks of General Electric.Other trade names used in this document may be trademarks or registered trademarks of themanufacturers or vendors of the respective products.Intended use Use this product only for the purpose it was designed for; refer to the data sheet and userdocumentation. For the latest product information, contact your local supplier or visit us onlineat www.gesecurity.com.FCC compliance This equipment has been tested and found to comply with the limits for a Class A digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference when the equipment is operated in a commercialenvironment. This equipment generates, uses, and can radiate radio frequency energy and, ifnot installed and used in accordance with the instruction manual, may cause harmfulinterference to radio communications.You are cautioned that any changes or modifications not expressly approved by the partyresponsible for compliance could void the user's authority to operate the equipment.