GE JGSS86SPSS Installation Instructions Manual

GE JGSS86SPSS Installation Instructions Manual Manual pdf 2 page image

CONVERTING TO PROPANEGAS (OR CONVERTINGBACK TO NATURAL GASFROM PROPANE)This range leaves the factory set for use withnatural gas. If you want to convert to propanegas, the conversion must be performed by aqualified propane gas installer.The conversion orifices and instructions canbe found on back of the range.Keep these instructions and all orifices in caseyou want to convert back to natural gas.DIMENSIONS ANDCLEARANCESProvide adequate clearances between therange and adjacent combustible surfaces.These dimensions must be met for safe use ofyour range.Allow 30” (76.2 cm) minimum clearancebetween burners and bottom of unprotectedwood or metal cabinet, or allow a 24” (61 cm)minimum when bottom of wood or metal cabinetis protected by no less than 1/4” (6.4 mm) thickflame-retardant millboard covered with no lessthan No. 28 MSG sheet metal (.015” [.38 mm]thick), .015” (.38 mm) thick stainless steel, .025”(0.64 mm) aluminum or .020” (0.5 mm) copper.Installation of a listed microwave oven orcooking appliance over the cooktop shallconform to the installation instructions packedwith that appliance.For island installation, maintain 2-1/2” minimumfrom cutout to back edge of countertop and3” minimum from cutout to side edges ofcountertop.DIMENSIONS AND CLEARANCES (CONT.)GAS PIPE AND ELECTRICAL OUTLET LOCATIONSCAUTION To preventdrafts from affecting burneroperation, seal all openingsin floor under appliance andbehind appliance wall.INSTALLATION AT HIGH ALTITUDEOver 6000ft, product configured for natural gas or propane requires installation of kit (WB28X29254 for naturalgas and WB28X29255 for propane gas). Follow the instructions included with the kit.18”Minimumto cabinetsabove counter0”Minimumto cabinetsbelowcooktop30”Minimum30”16”Max tocabinetsabovecounter 6” Right side6” Left sideMinimumto side wall36”30”2”5”4”9”13”14 1/2”24”4 1/2”12 1/2”Side WallGasandelectricalsupply1 1/8"26 7/8"30"43 7/8"29 1/2"w/ handlew/o handle36 1/4" ± 1/4For all installations, install the required rear trim to back of range with 4 screws provided.ScrewsRear TrimBack ofRangeRear of RangePressureRegulatorLocationScrews toRemoveTerminalBlockTerminalBlockCoverPropaneConversionKit