GE Appliances XL44 JGBP24 Use & Care Manual And Installation Instructions

Also see for Appliances XL44 JGBP24: Use and care & installation guide Use and care & installation guide

Contents

GE Appliances XL44 JGBP24 Use & Care Manual And Installation Instructions Manual pdf 22 page image

OPERATING THE SELF-CLEANING(continued)OVENHow to Set the Oven for CleaningOVEN SET OVEN TEMP1. Turn the OVEN SET knob to CLEAN. Push in andturn the OVEN TEMP knob to CLEAN. The controlswill snap into the final position when the CLEANlocation is reached.. Slide the latch handle to the right -.-as far as it will go.Never force the door latch handle. IllllllllForcing the handle may damagethe door lock mechanism.3. Set the automatic oven timers.Make sure the range clock is set to the correct timeof day. Clear the DELAY START and STOP TIMEdials of any previous timed cooking or cleaningfunction by: one at a time, push the DELAY STARTand STOP TIME dials in and turn the dials. Using alight touch, continue turning the dial until it "pops"out. Both dials should now be in the out position.Decide on the cleaning hours necessary.Light to Moderate Soil--2-3 hours (thin spillsand light spatters).Heavy Soil--4 hours (heavy, greasy spills andspatters).Add these hours to the present time of day, then pushin and turn the STOP TIME dial clockwise to this laterstop time.The oven door gets hot during self-cleaning. DO NOTTOUCH.The CLEANING light will glow, indicating thecontrols have been set correctly and the clean cyclehas begun. If a delayed start has been selected, theCLEANING light will not glow until the start timehas been reached and the clean cycle begins. The doorwill lock approximately 20 minutes after the cleancycle has begun.4. When the clean cycle is complete,you will be able to slide the doorlatch handle to the left as far as itwill go and open the door.1111111Never force the door latch handle. If youcannot slide the latch easily to unlock the door,allow additional time for cooling.Turn the OVEN TEMP knob to OFF.After a Clean CycleAfter a clean cycle, you may notice some white ashin the oven. Just wipe it up with a damp cloth.If white spots remain, remove them with a soap-filled steel wool pad. Be sure to rinse thoroughlywith a vinegar and water mixture. These depositsare usually a salt residue that cannot be removed bythe clean cycle.If the oven is not clean after one cycle, the cyclemay be repeated.If the shelves have become hard to slide, wipe theshelf supports with cooking oil.NOTE: You cannot set the oven for cooking until theoven is cool enough for the door to be unlatched.'9")