16NOTE:When replacing the moving antenna, make sure the plastic stirrer spacers are correctly in place.13. To remove motor syncro.1) Push left side of stopper in centre of cover stirrer and seperate it from cavity.2) Hold side stoppers of cover stirrer with both hands and pull down. Then take off the cover stirrer out ofthe oven cavity3) Remove three fixture supporter stirrer holding the stirrer *t.4) Remove stirrer *t from the cavity.5) Insert a flat-head type screwdriver tray front equivalent approx.6) Carefully lift up the floor tray by using the screwdriver until the floor shelf is lifted up over the level ofoven opening front.7) Remove tray from the cavity.8) Remove three fixture supporter stirrer holding the stirrer *u.9) Remove stirrer *u from the cavity.10) Remove two screws holding the motor syncro.11) Remove motor syncro from the cavity.12) Reverse the above steps for reassembly.