Canon Super G3 Fax Board-J1 Service Manual

Canon Super G3 Fax Board-J1 Service Manual Manual pdf 93 page image

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON SUPER G3FAX BOARD-J1 REV.0 JUNE 2001CHAPTER 6 ERROR CODES6-9##674 (transmission) At time of V.34 transmission, the procedure fails to move fromphase 3 or phase 4 to control channel, causing a T1 time-outand releasing the line.Cause: In phase 3 or phase 4, the line of the receiving side is cut or the signal ofthe receiving side cannot be detected.Remedy: Use service data #1 SSSW SW28 bit 0 to prohibit the V.8/V.34 procedure ofthe caller.Use service data #2 MENU No. 07 to increase the transmission level withinthe range between -8 and -15 dBm.##675 (reception) At time of V.4 reception, the procedure fails to move fromphase 3 or phase 4 to control channel, causing a T1 time-outand releasing the line.Cause: In phase 3 or phase 4, the line of the transmitting side is cut or the signal ofthe transmitting side cannot be detected.Remedy: Use service data #1 SSSW SW28 bit 1 to prohibit the V.8/V.34 procedure ofthe caller.Use service data #2 MENU No. 07 to increase the transmission level in therange between -8 and -15 dBm.