14 Before Using the Machine2 Prepare to load paper.(1) Open the Sheet Feeder Cover and pull out thePaper Support.Put your finger in the rounded indent of thePaper Support and pull it out until it stops.(2) Open the Front Tray.Put your finger in the indent on the top of theFront Tray and open it gently.(3) Extend the Output Paper Support.(4) Press the Paper Feed Switch so that theRear Tray lamp (A) lights.3 Load the paper.(1) Load the paper in the Rear Tray with the printside facing UP.(2) Align the paper stack against the Cover Guideon the right side of the Paper Support.(3) Pinch the Paper Guide and slide it against theleft side of the paper stack.4 Specify the page size and media type settings according to the loaded paper.NoteYou can also select the paper source with the printerdriver. For details, refer to the PC Printing Guide on-screen manual.NoteMake sure that the Cover Guide is set uprightwhen you load paper in the Rear Tray.Importantz Do not load higher than the Load Limit Mark(B).z Do not slide the Paper Guide too hard. Papermay not be fed properly.Notez When performing copy direct printing without using a computer, select the size and type of theloaded paper in Page size and Media type in each mode. For details on settings in each menu,see “Setting Items” on page 21 and page 26.z When using the machine connected to a computer, select the size and type of the loaded paperin Page Size (or Paper Size) and Media Type in the printer driver.For details on printer driver settings, see “Printing with Windows” on page 33 or “Printing withMacintosh” on page 34.(A)(4)(2)(1)(3)(B)(3)(1) (2)
