Advanced Guide > Troubleshooting > Print Head Holder Does Not Move to the Position for ReplacingPrint Head Holder Does Not Move to the Position for ReplacingCheck 1: Are all lamps on the Operation Panel off?Check if any lamp on the Operation Panel is lit.The Print Head Holder will not move unless the power is on. If all the lamps on the Operation Panelare off, close the Scanning Unit (Cover) and turn the machine on.While any lamp on the Operation Panel is flashing, the machine is initializing. Wait until the lampstops flashing and remains lit, and then open the Scanning Unit (Cover) again.Check 2: Is an error message displayed on the LCD?Close the Scanning Unit (Cover), follow the directions displayed in the error message to resolve theerror, and then reopen it. For details on how to resolve the error, see An Error Message Is Displayedon the LCD.Check 3: Has the Scanning Unit (Cover) been left open for 10 minutes orlonger?If the Scanning Unit (Cover) is left open for more than 10 minutes, the Print Head Holder moves tothe right to prevent the Print Head from drying out. Close and reopen the Scanning Unit (Cover) toreturn the Print Head Holder to the center.Check 4: Has the machine been printing continuously for a longperiod?Close the Scanning Unit (Cover), wait a while, then reopen it.If the machine has been printing continuously for a long time, the Print Head Holder may not move tothe center since the Print Head may overheat.NoteOpening the Scanning Unit (Cover) while printing moves the Print Head Holder to the right. Closethe Scanning Unit (Cover), and reopen it after printing finishes.Page topPage 974 of 1127 pagesPrint Head Holder Does Not Move to the Position for Replacing
