Canon Finisher-R1 Service Manual

Also see for Finisher-R1: INSTALLATION PROCEDURE Circuit Diagram General Timing Chart/General Circuit Diagram INSTALLATION PROCEDURE Service manual

Contents

Canon Finisher-R1 Service Manual Manual pdf 41 page image

Chapter 22-17roller (lower) does not rotate because the stack ejection lower roller clutch (CL32) is disengaged. The paper in theprocessing tray is detected by the processing tray paper sensor (PI38).When the paper is delivered to the processing tray, the swing motor (M36) starts and raises the swing guide. Whenthe swing guide home position sensor (PI35) detects the rising of the swing guide, the swing guide motor stops andholds the swing guide at the raised position.After the processing tray paper sensor detects the paper, the aligning motor (M33/M34) starts and aligns the paper.F-2-23■ Last SheetWhen alignment of the last sheet completes, the finisher controller PCB moves the aligning plate to alignmentposition with the aligning motor (M33/M34) (with the paper held with the aligning plate). Then the finisher controllerPCB staples at the specified staple position.After stapling, the finisher controller PCB starts the swing motor (M36) and lowers the swing guide. Then the stackis ejected by the stack delivery roller, return roller, and rear endassist guide.F-2-24StaplerReturn rollerStack ejection rollerSwing guide1st delivery rollerProcessing trayRear endassist guideReturn rollerStaplerStack ejection rollerSwing guide