Canon CX-G2400 User Manual

Also see for CX-G2400: Getting started guide Basic operation guide

Contents

Canon CX-G2400 User Manual Manual pdf 161 page image

156Chapter 4 TroubleshootingCondition SolutionThe printing is blurred. Confirm that the paper set (size, shape, and type) matches the paper(size, shape, and type) configured by the application software orprinter driver.Clean the print head. (P.109)If you are using the printer at low temperature (Room temperature is14 degrees Celsius (57 degrees Fahrenheit) or lower) :Open the [Utility] tab in the printer driver and then select the [LowTemperature Print Mode] in the [Special Settings]. (P.82)The color deviation appears on theprint.Confirm that the paper set (size, shape, and type) that displays colordeviation matches the paper (size, shape, and type) configured by theapplication software or printer driver is the same.Adjust the position of the print head. (P.113)Set the resolution to [Input resolution 1200dpi] (prioritize imagequality) and then print. (P.55)If you have several printers, check that you have not changed theprinter and transport unit combinations. Because accurate adjustmentsare made between each printer and its transport unit, it is not possibleto use a transport unit of another printer.The halftone representation is coarse. Open [Color] tab of the printer driver, and set the [Half-tone] to [ErrorDiffusion]. (P.55)The area around characters or the layerareas appear uneven.Open the printer driver's [Color] tab and set the [Half-tone] to [ErrorDiffusion]. (P.55)Confirm that the paper set (size, shape, and type) matches the paper(size, shape, and type) configured by the application software orprinter driver.During micro margin printing, theprint position and margins are offalignment.Adjust the print position and trimming position for micro marginprinting. (P.47)If you have several printers, check that you have not changed theprinter and transport unit combinations. Because accurate adjustmentsare made between each printer and its transport unit, it is not possibleto use a transport unit of another printer.