Campbell Hausfeld ARCITECH WS2100 Operating Instructions And Parts Manual

Contents

limited warranty

Campbell Hausfeld ARCITECH WS2100 Operating Instructions And Parts Manual Manual pdf 2 page image

2Operating Instructions and Parts ManualInverter Technology Arc Welderparameters. (115 volts +/- 10%)5. Green LED – On = ready to weld.Controls – Back Panel (See Figure 3)1.On/Off Switch: O = Off I = On2.Power Cord inputGeneral SafetyDanger means ahazard that willcause death or serious injury if thewarning is ignored.Warning means ahazard that couldcause death or serious injury if thewarning is ignored.Caution means ahazard that maycause minor or moderate injury if thewarning is ignored. It also may mean ahazard that will only cause damage toproperty.! CAUTION! WARNING! DANGERNote: Note means any additionalinformation pertaining to the productor its proper usage.Alwayskeep afire extinguisher accessiblewhile performing arcwelding operations.● Before starting or servicing anyelectric arc welder, read andunderstand all instructions. Failureto follow safety precautions orinstructions can cause equipmentdamage and or serious personalinjury or death. For additionalsafety information, obtain a copy ofANSI Standard Z49.1 - Safety inWelding and Cutting. Thispublication may be ordered fromthe American Welding Society, 550NW LeJune Rd., Miami, FL 33135.● All installation, maintenance, repairand operation of this equipmentshould be performed by qualifiedpersons only in accordance withnational, state, and local codes.Im-properuse of electric arc welderscan cause electric shock,injury, and death! Take allprecautions described inthis manual to reduce the possibility ofelectric shock.● Verify that all components of thearc welder are clean and in goodcondition prior to operating thewelder. Be sure that the insulation! WARNING! WARNINGon all cables, electrode holders, andpower cords is not damaged.Always repair or replace damagedcomponents before operating thewelder. Always keep welder panels,shields, etc. in place when operatingthe welder.● Always wear dry protective clothingand welding gloves, and insulatedfootwear.● Always operate the welder in aclean, dry, well ventilated area. Donot operate the welder in humid,wet, rainy, or poorly ventilatedareas.● Be sure that the work piece isproperly supported and groundedprior to beginning any electric arcwelding operation.● Coiled welding cable should bespread out before use to avoidoverheating and damage toinsulation.Never immerse theelectrode orelectrode holder in water. If the welderbecomes wet for any reason, beabsolutely certain that it is completelyclean and dry prior to attempting use!● Always shut the equipment off andunplug the power prior to movingthe unit.● Always attach the ground lead first.● Verify that the work piece issecurely grounded.● Always shut off electric arc weldingequipment when not in use andremove the electrode from theholder.● Never allow any part of the body totouch the electrode and ground orgrounded work piece at the sametime.● Awkward welding conditions andpositions can be electricallyhazardous. When crouching,kneeling or at elevations, be sure toinsulate all conductive parts, wearappropriate protective clothing, andtake precautions to prevent injuryfrom falls.● Never attempt to use thisequipment at current settings orduty cycles higher than thosespecified on the equipment labels.! DANGERwww.chpower.comFigure 2 - Front Panel ControlsElectrode Polarity ChartRod Type DCEP DCEN+ -6011 Deep Penetrating x6013 General Purpose x x7014 Fast Fill x x7018 High Strength xAuto Strike x xAluminum xStainless xHardface xFigure 3 - Back Panel Controls1 122345x = recommended