Menu
Cadillac 2010–11 STS User Manual
   |
Top PostREMOVALCaution: When performing service onor near the SIR components or the SIRwiring, the SIR system must be dis-abled. Failure to observe the correctprocedure could cause deployment ofthe SIR components, personal injury, orunrequired SIR system repairs.1. Record radio anti-theft code and sta-tion presets.2. Turn off all lamps and accessories.3. Turn ignition switch to OFF position.4. Open battery ground cable clamp lock-ing lever cover (3) to release clamplocking lever (2), Fig. 8.5. Remove battery ground cable clampfrom battery.6. Open battery positive cable cover (1)and rotate cable clamp lever (2) to dis-engage clamp, Fig. 9.7. Remove battery positive cable clampfrom battery.8. Remove battery hold down retainerbolt (1) and retainer, Fig. 10.9. Remove battery insulator (2) from bat-tery, Fig. 10.10. Remove battery from vehicle.INSTALLATION1. Install battery to vehicle.2. Install battery insulator (2) to battery,Fig. 10.3. Install battery hold down retainer andbolt. Torque bolt to 13 ft. lbs.4. Install battery positive cable clamp tobattery, Fig. 9.5. Install battery ground cable clamp tobattery, Fig. 8.6. Perform power sunroof calibration asfollows:a. Turn ignition switch to RUN posi-tion.b. Turn power sunroof switch toclosed position. After sunroof fullycloses and motor stops, press andhold in switch for three seconds.c. Turn power sunroof switch to tilt po-sition. After sunroof reaches tilt po-sition and motor stops, press andhold in switch for three seconds.d. Turn power sunroof switch to fullopen position. After sunroof is fullyopen and motor stops, press andhold in switch for three seconds.e. Turn power sunroof switch toclosed position. After sunroof fullycloses and motor stops, press andhold in switch for three seconds.7. Perform power window calibration asfollows:a. Repeat these steps for each win-dow.b. Turn ignition switch to RUN posi-tion.c. Press power window switch todown position. After window is in fulldown position, press and holdswitch in down position for threeseconds.d. Press power window switch to upposition. After window is in full upposition, press and hold switch inup position for three seconds.8. Perform heat and A/C control head cal-ibration as follows:a. Turn ignition switch to RUN posi-tion.b. Simultaneously press Auto and Offbuttons, located on heat and A/Ccontrol head, for at least five sec-onds.c. After initiation, stepper motors willcycle from one stop to other. Youmay hear motors cycling while cali-brating.9. Reset all preset and theft codes previ-ously recorded to radio.10. Relearn tire pressure sensor systemper manufacturers instructions, if re-quired.BTY1200000000441Fig. 3 Windshield wiper armremovalBTY1200000000442Fig. 4 Air inlet grille panel removalBTY1200000000443Fig. 5 Battery heat shield lockingtab locationBTY1200000000444Fig. 6 Battery heat shieldremovalBTY1200000000445Fig. 7 Battery retainer removalCADILLAC2010–11 STS2 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved