Menu
CAN CHECKED MFD15 Quick Start Manual
Also see for MFD15: Quick start guideQuick start guide
  |
Version v0.2 www.canchecked.deInstallationWhen installing the display, you need to pay attention to a neat cabling. The powercable needs to be fused with 2A (optionally with 5A). The measurements for themounting hole and the screw holes can be found in the upper drawing.In addition, only the can bus cables (high/low) needs to be connected.Please make sure, to tighten the orange screws for the bracket carefully. Otherwiseyou will damage the casing.ImplementationAfter the start-up, the splash screen appears with the logo and an internal componenttest (can bus) is run.The display starts with the last selected view. If you press the encoder, the displaystops and shows a bar in the upper area.1) Shift light or warning LED (RGB)2) Menu bar (if display is stopped)3+4) current data display dependingon the selected viewIf you rotate the encoder, a redrectangle is shown with the currentposition. With another press, youselect the action:1-8: change viewSetup: Setup / Menu3+4: Change the sensorThe view of the data is selected inmenu under “views”. Choosebetween: single value, 2 values, 4values, 6 values, bargraph, YTdiagram, single needle, doubleneedle, bar+2wayOn questions regarding accessories or functionality please get in contact with us viaour homepage (www.canchecked.de) or via email (info@canchecked.de).1321 1 3 4 5 6 7 8 Setup354040.98RPMLambda12 |
Related manuals for CAN CHECKED MFD15
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved