CAME AX3024 Installation Manual

Also see for AX3024: Installation manual Installation manual Installation manual

CAME AX3024 Installation Manual Manual pdf 2 page image

p. 2 - Manual FA01165 -EN - 05/2018 - © CAME S.p.A. - Translated original instructionsWARNING!important safety instructions for people:READ CAREFULLY!PREMISE• T HIS PRODUCT SHOULD ONLY BE USED FOR THE PURPOSE FORWHICH IT WAS EXPLICITLY DESIGNED. A NY OTHER USE IS DANGEROUS.CAME S.P.A. IS NOT LIABLE FOR ANY DAMAGE CAUSED BYIMPROPER, WRONGFUL AND UNREASONABLE USE • KEEP THESE WARNINGS TOGETHERWITH THE INSTALLATION AND OPERATION MANUALS THAT COME WITH THE OPERATOR.B EFORE INSTALLING(CHECKING WHAT'S THERE: IF SOMETHING IS MISSING, DO NOT CONTINUE UNTIL YOUHAVE COMPLIED WITH ALL SAFETY PROVISIONS)• CHECK THAT THE AUTOMATED PARTS ARE IN PROPER MECHANICAL ORDER, THATTHE OPERATOR IS LEVEL AND ALIGNED, AND THAT IT OPENS AND CLOSES PROPERLY .M AKE SURE YOU HAVE SUITABLE MECHANICAL STOPS • I F THE OPERATOR IS TO BEINSTALLED AT A HEIGHT OF LESS THAN 2.5 M FROM THE GROUND OR OTHER ACCESSLEVEL, MAKE SURE YOU HAVE ANY NECESSARY PROTECTIONS AND /OR WARNINGS INPLACE • I F ANY PEDESTRIAN OPENINGS ARE FITTED INTO THE OPERATOR, THEREMUST ALSO BE A A SYSTEM TO BLOCK THEIR OPENING WHILE THEY ARE MOVING •M AKE SURE THAT THE OPENING AUTOMATED DOOR OR GATE CANNOT ENTRAP PEOPLEAGAINST THE FIXED PARTS OF THE OPERATOR • DO NOT FIT UPSIDE DOWN OR ONTOELEMENTS THAT COULD BEND. I F NECESSARY , ADD SUITABLE REINFORCEMENTS TO THEANCHORING POINTS • DO NOT INSTALL DOOR OR GATE LEAVES ON TILTED SURFACES• MAKE SURE ANY SPRINKLER SYSTEMS CANNOT WET THE OPERATOR FROM THEGROUND UP • M AKE SURE THE TEMPERATURE RANGE SHOWN ON THE PRODUCTLITERATURE IS SUITABLE TO THE CLIMATE WHERE IT WILL BE INSTALLED • FOLLOW ALLINSTRUCTIONS AS IMPROPER INSTALLATION MAY RESULT IN SERIOUS BODILY INJURY •I T IS IMPORTANT TO FOLLOW THESE INSTRUCTIONS FOR THE SAFETY OF PEOPLE. K EEPTHESE INSTRUCTIONS.I NSTALLING• SUITABLY SECTION OFF AND DEMARCATE THE ENTIRE INSTALLATION SITE TO PREVENTUNAUTHORIZED PERSONS FROM ENTERING THE AREA, ESPECIALLY MINORS ANDCHILDREN • B E CAREFUL WHEN HANDLING OPERATORS THAT WEIGH OVER 20 KG .I F NEED BE, USE PROPER SAFETY HOISTING EQUIPMENT • ALL OPENING COMMANDS(THAT IS, BUTTONS , KEY SWITCHES , MAGNETIC READERS, AND SO ON) MUST BEINSTALLED AT LEAST 1.85 M FROM THE PERIMETER OF THE GATE'S WORKING AREA ,OR WHERE THEY CANNOT BE REACHED FROM OUTSIDE THE GATE. A LSO, ANY DIRECTCOMMANDS (WHETHER BUTTONS , TOUCH PANELS, AND SO ON) MUST BE INSTALLED ATLEAST 1.5 M FROM THE GROUND AND MUST NOT BE REACHABLE BY UNAUTHORIZEDPERSONS • ALL MAINTAINED ACTION COMMANDS, MUST BE FITTED IN PLACES FROMWHICH THE MOVING GATE LEAVES AND TRANSIT AND DRIVING AREAS ARE VISIBLE •APPLY, IF MISSING, A PERMANENT SIGN SHOWING THE POSITION OF THE RELEASEDEVICE • BEFORE DELIVERING TO THE USERS, MAKE SURE THE SYSTEM IS EN12453 STANDARD COMPLIANT ( REGARDING IMPACT FORCES), AND ALSO MAKE SURETHE SYSTEM HAS BEEN PROPERLY ADJUSTED AND THAT ANY SAFETY, PROTECTION ANDMANUAL RELEASE DEVICES ARE WORKING PROPERLY • A PPLY W ARNING SIGNS WHERENECESSARY AND IN A VISIBLE PLACE, (SUCH AS, SUCH AS THE GATE'S PLATESPECIAL USER -INSTRUCTIONS AND RECOMMENDATIONS• K EEP GATE OPERATION AREAS CLEAN AND FREE OF ANY OBSTRUCTIONS . MAKESURE THAT THE PHOTOCELLS ARE FREE OF ANY OVERGROWN VEGETATION AND THATTHE OPERATOR'S AREA OF OPERATION IS FREE OF ANY OBSTRUCTIONS • D O NOTALLOW CHILDREN TO PLAY WITH FIXED COMMANDS, OR TO LOITER IN THE GATE'SMANEUVERING AREA. KEEP ANY REMOTE CONTROL TRANSMITTERS OR ANY OTHERCOMMAND DEVICE AWAY FROM CHILDREN, TO PREVENT THE OPERATOR FROM BEINGACCIDENTALLY ACTIVATED. • THE APPARATUS MAY BE USED BY CHILDREN OF EIGHTYEARS AND ABOVE AND BY PHYSICALLY, MENTALLY AND SENSORY- CHALLENGEDPEOPLE, OR EVEN ONES WITHOUT ANY EXPERIENCE, PROVIDED THIS HAPPENS UNDERCLOSE SUPERVISION OR ONCE THEY HAVE BEEN PROPERLY INSTRUCTED TO USE THEAPPARATUS SAFELY AND TO THE POTENTIAL HAZARDS INVOLVED. C HILDREN MUSTNOT PLAY WITH THE APPARATUS. CLEANING AND MAINTENANCE BY USERS MUST NOTBE DONE BY CHILDREN, UNLESS PROPERLY SUPERVISED • FREQUENTLY CHECK THESYSTEM FOR ANY MALFUNCTIONS OR SIGNS OF WEAR AND TEAR OR DAMAGE TO THEMOVING STRUCTURES, TO THE COMPONENT PARTS , ALL ANCHORING POINTS , INCLUDINGCABLES AND ANY ACCESSIBLE CONNECTIONS . K EEP ANY HINGES, MOVING JOINTSAND SLIDE RAILS PROPERLY LUBRICATED • PERFORM FUNCTIONAL CHECKS ON THEPHOTOCELLS AND SENSITIVE SAFETY EDGES, EVERY SIX MONTHS. TO CHECK WHETHERTHE PHOTOCELLS ARE WORKING, WAVE AN OBJECT IN FRONT OF THEM WHILE THEGATE IS CLOSING; IF THE OPERATOR INVERTS ITS DIRECTION OF TRAVEL OR SUDDENLYSTOPS, THE PHOTOCELLS ARE WORKING PROPERLY. THIS IS THE ONLY MAINTENANCEOPERATION TO DO WITH THE POWER ON. CONSTANTLY CLEAN THE PHOTOCELLS'GLASS COVERS USING A SLIGHTLY WATER- MOISTENED CLOTH; DO NOT USE SOLVENTSOR OTHER CHEMICAL PRODUCTS THAT MAY RUIN THE DEVICES • I F REPAIRS ORMODIFICATIONS ARE REQUIRED TO THE SYSTEM, RELEASE THE OPERATOR AND DO NOTUSE IT UNTIL SAFETY CONDITIONS HAVE BEEN RESTORED • C UT OFF THE POWERSUPPLY BEFORE RELEASING THE OPERATOR FOR MANUAL OPENINGS AND BEFORE ANYOTHER OPERATION , TO PREVENT POTENTIALLY HAZARDOUS SITUATIONS. R EAD THEINSTRUCTIONS I F THE POWER SUPPLY CABLE IS DAMAGED, IT MUST BE REPLACED BYTHE MANUFACTURER OR AUTHORIZED TECHNICAL ASSISTANCE SERVICE, OR IN ANYCASE, BY SIMILARLY QUALIFIED PERSONS, TO PREVENT ANY RISK • I T IS FORBIDDENFOR USERS TO PERFORM ANY OPERATIONS THAT ARE NOT EXPRESSLY REQUIRED OFTHEM AND WHICH ARE NOT LISTED IN THE MANUALS. FOR ANY REPAIRS, MODIFICATIONS/ ADJUSTMENTS, AND FOR EXTRA- ORDINARY MAINTENANCE, CALL TECHNICALASSISTANCE • LOG THE JOB AND CHECKS INTO THE PERIODIC MAINTENANCE LOG.F URTHER RECOMMENDATIONS FOR ALL•KEEP CLEAR OF HINGES AND MECHANICAL MOVING PARTS • DO NOT ENTER THEOPERATOR'S AREA OF OPERATION WHEN IT IS MOVING • DO NOT COUNTER THEOPERATOR'S MOVEMENT AS THIS COULD RESULT IN DANGEROUS SITUATIONS • ALWAYSPAY SPECIAL ATTENTION TO ANY DANGEROUS POINTS , WHICH HAVE TO BE LABELEDWITH SPECIFIC PICTOGRAMS AND/ OR BLACK AND YELLOW STRIPES • WHILE USINGA SELECTOR SWITCH OR A COMMAND IN MAINTAINED ACTIONS, KEEP CHECKING THATTHERE ARE NO PERSONS WITHIN THE OPERATING RANGE OF ANY MOVING PARTS, UNTILTHE COMMAND IS RELEASED • T HE GATE MAY MOVE AT ANY TIME AND WITHOUTWARNING • A LWAYS CUT OFF THE MAINS POWER SUPPLY BEFORE PERFORMING ANYMAINTENANCE OR CLEANING.Danger of hand crushingDanger! High voltage.No transiting while the barrier is movingDanger of foot crushing