BabyGo Tojo Instruction Manual

Contents

installation in the car

BabyGo Tojo Instruction Manual Manual pdf 15 page image

15ROUTING OF THE SEAT BELT1. For group 0+(less than 13kg) use, put the child restraint in a rear-facing position and use thebase support on the seat of car.Warning!: To ensure child‘s back is evenly supported, do not put morethan one nappy on the child and make sure the nappy is not likely foldedat the back.2. For group (9 – 18kg)use, place the car seat in forward facing position on the seat of the car.TWO KINDS OF INSTALLATION METHODS FOR CHILD SAFETY SEAT1. Group 0+, rear-facing installation (Suitable child‘s weight from newborn to 13kg ), pleasemake sure to use rear-facing position (Fig ), the seat must be located at the maximum tiltangle (3 stalls)and use base support.And make sure to use red clip.Note: Extreme danger. Do not use a rear facing child restraint in passengerseats equipped with airbag! Do not use in forward facing position whenchild‘s weight under 9kg.2. Group forward facing installation (Suitable child‘s weight between 9 to 18 kg), please makesure to use forward facing position (Fig ). And make sure to use red clip. Install child safety carseats with three-point seat beltsRear-facing position15Car Seat